Configure 2811 as transcoding device

[Amit Singh2000]

HI Guys,

I need your help on this..I have a customer going to install CUCM solution on multiple site.. because of bandwidth limitation some sites will be running G729 over wan and some sites are running G711.... How do i configure a cisco 2811 router which has PVDM 64 installed in it as a trancoding device..

In esence i want sites running G711 and sites running G729 talk to each other and enjoy other fancy features like conference.

Thanks in advance

regards

[Jaime Valencia]

Configuring Enhanced Conferencing and Transcoding for Voice Gateway Routers

http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/interop/intcnf2.html

CallManager and IOS Gateway DSP Farm Configuration Example

http://www.cisco.com/en/US/partner/products/sw/voicesw/ps556/products_configuration_example09186a0080334294.shtml

HTH

java

if this helps, please rate

[sebastiandm]

Follow the attached document you should be fine.

Please rate if useful.

[Amit Singh2000]

Hello my friend.

Thanks a lot for your reply.. I forgot to mention that we are using call manager 7.0 version..1 publisher and 3 subscriber servers...does this configuration still valid for my solution or configuration for transcoding will change ??

regards

[Jaime Valencia]

It still works, the interface of 2nd link is just a little changed but all the IOS commands are exactly the same for any version.

HTH

java

if this helps, please rate