10-07-2012 10:00 AM - edited 03-16-2019 01:34 PM
Hi,
I have a Cisco 1861 Integrated Services Router with 4 FXS ports and 2BRI.
Well, as it is known, the FSX ports is for telephones, fax, etc.My deal is to connect the router to the PSTN network with a single RTC thru a analog port, but I'm not sure how it's possible because all of them are FXS.
As other hardware manufactures I worked on before, I could deactivate the FXS signal and start configuring as FXO, but i dont know how to make this on Cisco.
Can anyone advice me?
Thank you!
Solved! Go to Solution.
10-07-2012 10:12 AM
It is not possible to do that. You will need to instal FXO ports.
10-07-2012 10:12 AM
It is not possible to do that. You will need to instal FXO ports.
10-07-2012 10:14 AM
Hi,
Thank for your quickly reply.
So the option its about to configure in the BRI ports then.
10-07-2012 10:15 AM
You will need BRI service from telco to use the BRI ports.
Thanks for the nice rating and good luck!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide