cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
312
Views
0
Helpful
2
Replies

configure toll fraude prevention c880voice

albertgascon
Level 1
Level 1

Hello: I need to configure toll fraude prevention in three of my routers, Ios versions:

c880voice-universalk9-mz.124-24.T6.bin

c880voice-universalk9-mz.150-1.M8.bin

c880voice-universalk9-mz.150-1.M8.bin

 

I used the following guide, which according to Cisco, is intended for ios version 12.1 or later:

 

http://www.cisco.com/c/en/us/support/docs/voice-unified-communications/unified-communications-manager-express/107626-cme-toll-fraud.html

 

This is the configuration I planned to use, but my routers do not support any of the commands under "voice service voip",

 

Router> enable

Router# configure terminal

Router(config)# voice service voip

Router(conf-voi-serv)# ip address trusted authenticate

Router(conf-voi-serv)#ip address trusted call-block cause call-reject

Router(conf-voi-serv)# ip address trusted list

Router(cfg-iptrust-list)#ipv4 10.0.0.0 255.0.0.0

Router(cfg-iptrust-list)#end

 

I have been seaching for equivalent commands but haven't found any.

 

Is there anyone with experience configuring toll fraud prevention for devices with IOS release older than 15.1(2). What am I doing wrong?

 

Thanks in advance!

2 Replies 2

Ayodeji Okanlawon
VIP Alumni
VIP Alumni

This feature did not exist pre 15.1(2). If you need it I suggest you upgrade your IOS. There is no concept of toll fraud prevention in older IOS releases

Please rate all useful posts

vemanyam
Level 1
Level 1

As Ayodeji suggested, it is recommended to upgrade the IOS for this feature.

Or esle, you can try configuring Access-Lists to block the traffic coming from un-wanted IPs