- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-07-2017 05:09 AM - edited 03-17-2019 11:44 AM
Hello,
When I run "show controllers e1 call-counters" I get the following output:
Controller E1 0/0/0 does not support displaying this data
Total DS0's Active High Water Mark: 0
Total Calls since System Bootup: 0
PID: CISCO2921/K9
IOS: c2900-universalk9-mz.SPA.154-3.M2.bin
what is the reason of this result? How can I activate this feature in E1?
Many thanks
Solved! Go to Solution.
- Labels:
-
Other IP Telephony
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-07-2017 05:25 AM - edited 12-07-2017 05:36 AM
This is a chassis specific command supported in 4000, AS5300, AS5400 series.
It is not supported in 29xx series.
Please rate if you find this helpful.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-07-2017 05:25 AM - edited 12-07-2017 05:36 AM
This is a chassis specific command supported in 4000, AS5300, AS5400 series.
It is not supported in 29xx series.
Please rate if you find this helpful.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-13-2017 06:40 AM
