CUBE Licenses for router 3925

[slaam2013]

Hello all

I have a cisco router 3925 , with 30 CUBE licenses . I have already received two license as white papers with a CD inlcude FL-CUBE-25 and FL-CUBE-5 whithout any PAK . How can i check the licenses are ok on my router?. Are these licenses come with the router , included with the oruter?.

Thanks

[slaam2013]

Hello all

i need just a confirmation that there is no commands should be added to my router , the only confirmation that i bought the licenses the two papers which came with the router , is this true?.

Thanks

[Ayodeji Okanlawon]

CUBE Licenses are right to use licenses..SO they are just Paper licenses and no PAK comes with them

Please rate all useful posts

"opportunity is a haughty goddess who waste no time with those who are unprepared"

[slaam2013]

Thanks for your answer , so there any command should be done on the router.I need your help to start my configuration on CUBE router as a setup , because i did not activate the services on my CUCM cluster where i am still waiting the licenses .

voice service voip

  allow-connections sip to sip

no supplementary-service sip moved-temporarily

no supplementary-service sip refer  redirect ip2ip

  sip

    bind control source-interface GigabitEthernet0/1

    bind media source-interface GigabitEthernet0/1

voice class codec 1 
codec preference 1 g711alaw
 codec preference 2 g711ulaw 
codec preference 3 g729r8 
codec preference 4 g729br8 
codec preference 5 g723ar53
 
dial-peer voice 1 voip
answer-address .T
incoming calles-number .T
dtmf-relay rtp-nte
voice-class codec 1 
session protocol sipv2

dial-peer voice 2 voip
destination-pattern ....
session-target IPv4:X.X.X.X     (IP of CUCM)
dtmf-relay rtp-nte
voice-class codec 1 
session protocol sipv2
dial-peer voice 3 voip 
description SIPOutgoing Calls 
 destination-pattern .T 
session protocol sipv2 
session target ipv4:x.x.x.x:5060       (ITSP IP)
voice-class codec 1 
voice-class sip dtmf-relay force rtp-nte 
dtmf-relay rtp-nte 
no vad 


sip-ua
Is there any missing command , is it necessary to use MTP ?.

thanks