hi,
I have reviewed the documentation and this community but I don't have been able to configure Network Based Recording in CUBE.
My environment is:
- CUCM 10.5
- VGW 3925 IOS 15.6(3)M8
IOS configuration:
http client cache memory file 2500
http client cache refresh 864000
ip http server
ip http authentication local
ip http secure-server
ip http max-connections 100
ip http timeout-policy idle 60 life 86400 requests 10000
ip http client source-interface <loopback cube>
uc wsapi
message-exchange max-failures 2
source-address <loopback cube>
probing interval keepalive 5
probing max-failures 5
!
provider xmf
remote-url 1 http://<cucm call processing>:8090/ucm_xmf
end
and I always got:
show wsapi registration all
Provider XMF
=====================================================
I use the VGW's loopback as destination address of the SIP Trunk to VGW.
I don't know where is the error. I have the following licenses:
Suite License Information for Module:'c3900'
--------------------------------------------------------------------------------
Suite Suite Current Type Suite Next reboot
--------------------------------------------------------------------------------
FoundationSuiteK9 None None None
securityk9
datak9
AdvUCSuiteK9 None None None
uck9
cme-srst
cube
Technology Package License Information for Module:'c3900'
------------------------------------------------------------------------
Technology Technology-package Technology-package
Current Type Next reboot
------------------------------------------------------------------------
ipbase ipbasek9 Permanent ipbasek9
security None None None
uc uck9 Permanent uck9
data None None None
Appreciate any comments.
[UPDATE] The issue was an access-list. now working without problems except with CVP. Seem that it is supported with CVP Survivability TCL scripts with Cisco IOS 15.6(1)T.
Regards,