CUCM Upgrade 8.0 to 8.6 Question

[edumas001]

Hi guys,

i have a 8.0.2 CUCM and i want to go to 8.6

I was wondering if rebooting the server after the installion of "ciscocm.refresh_upgrade_v1.0.cop.sgn"  can compromise the update because i did install it a week ago and meanwhile the servers had an outage hence rebooting. If so is there a workaround ?

**I havent started the actual update yet just install the above mentioned file**

Thanks,

Eric D.

[Leo Salcie Tejeda · Accepted solution]

Hi Edu,

It's ok to reboot the server after has been installed. Just one advcie, be sure to install the right COP file because it cannot be uninstalled (Cisco TAC is the only want able to do it).

Regards

[edumas001]

Thank you verry much for your quick answer !!!

Eric D.