06-26-2010 08:13 AM - edited 03-15-2019 11:25 PM
Hi,
CUCM7.1.3 configured mobile connect feature but I have below issue
-pickup by IP Phone and send to remote destinatio phone, and send to IP Phone again, works okay
-pickup by remote destion phone and send to IP Phone successfully, at this time, when I send back to remote destion phone, got error message "mobile phone number error" when I choose the "Send,,,," option from <Mobility> softkey.
the problem is, the first attempt to send to remote destionation phone works okay but problem when I send back to remote destinaiton phone which I got the call from remote destionation phone. problme on the re-sending call.
Looks it allow only one hop and problem with error message "mobile phone number error" in 2nd hop,,,,, I don't think this is configuration issue because works okay for the 1st hop in either direction.
Advice please,
08-12-2010 12:33 AM
Hi Cjrchoi11,
I have same issue, Do you have the solution ?
It is OK to resend call to remote destination for MGCP link with protocol Q-Siginal, but It is NI2 in HK.
Rgds
Dennis
08-25-2010 08:34 PM
Same issue here but using CUCM 7.1.5.11901-1. Has anyone found a solution?
Any help would be appreciated.
Dave
08-26-2010 12:39 AM
Hi,
I opened TAC case, upgraded to 7.1.5.31900-3 to fix it
Rgds,
Dennis
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide