07-31-2013 02:59 AM - edited 03-16-2019 06:38 PM
Hi
I have a CUCME 9.5 and I am unable to save the config from the GUI. I get the message other telnet session active.
I seem to remember this was a bug in earlier versions is this the case in 9.5.
07-31-2013 04:45 AM
Hi
I am not sure how is this bug. As far as I know this is working as design.
-Used command show users, find the telnet sessions.
-Do a clear line < > , in order to delete those sessions.
-Added the following commands also:
1)exec-timeout 10 ( telnet session will be disconnected after 10 min of inactivity)
2)logout-warning 60 (60 sec before automatically logging off router will send warning
message to user to save config)
-Reload the router.
Regards
Ronak Patel
Rate all helpful post by clicking stars below the answer.
07-31-2013 05:03 AM
Thanks I will try what you suggest. I did find a bug for earlier version. I will let you know how it goes.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide