CUVA with Cisco IP Phone & CUCME

[Pawel Lenart]

Hi all,

I have a small problem. Recently I setup CUVA (2.1.1) for testing with our CUCME (8.6) and couple IP phones (Cisco 7960G running newest firmware & SCCP). When I run CUVA with IP communicator everything is working fine (video, audio etc) is working. When I connect my PC to the back of the phone and I want to use CUVA with an IP phone my CUVA can't detect IP phone. There is no ACL on my router. I can access phone build in http website, I can see traffic is going through phone switch but for some reason I can't get it to work. Any ideas?

Reagrds,

Pawel

[ronpatel]

Hi Pawel,

What is the OS of the PC. We do not support OS like Win 7.

Regards

Ronak Patel

Rate hellpful posts.

[Pawel Lenart]

Yes it is Windows 7. Are you planning to support Windows 7 in future?

[ronpatel]

Hi

I  dont think so it will be supported. Windows 7 will be certified for the  next generation of CSF-based video clients (CUCI-MOC, CUCI-Connect, and  CUPC 8.x)

If  you are certifed partner, You can raise cisco PDI case to get the  roadmap information. To open case at PDI go to cisco.com/go/pdihelpdesk.  It is free service.

Regards

Ronak patel

Please rate all helpful post by clicking stars below the answer.

[Pawel Lenart]

Ok so it's not supported by Cisco but did anyone else managed to find solution for this problem?