dialing from missed call directory

[ray2mba]

I have a sip trunk to cucm ver 10.5, and i am trying to go to missed call or received calls and be able to dial from there when I received a call, what ever i do, i see that the sip protocol is striping any digit that i add via the calling party transformation pattern. I am wondering if this is even possible, it use to work with TDM ISDN port but not sip. anyone has any idea?>
 

[Mohammed al Baqari]

Please share the topology and the version of devices used.

[ray2mba]

 (C3900e-UNIVERSALK9-M), Version 15.2(1)T1, RELEASE SOFTWARE (fc1)

CISCO3945 is my CUBE to the provider and i have a sip trunk pointing to cucm ver 10.4. I am sending 10 digit to the cucm from the provide. I have 7965 and 7975 cisco phone.

on the sip trunk under 'Incoming Calling Party Settings' i checked the check box for use "Use Device Pool CSS"

on the device pool for the phones, i put a css that can reach a calling party transformation 91(2-9)xx(2-9)xxxxxx. 

at the device pool level for the phone,

Incoming Calling Party Settings

National Number

International Number

Unknown Number

Subscriber Number

 

Router#
Router##sho cube st
CUBE-Version : 8.8
SW-Version : 15.2(1)T1,, Platform CISCO3945-CHASSIS
HA-Type : hot-standby-chassis-to-chassis
Licensed-Capacity :200

PHSIPSBC5.8-01#

IOS ver is (C3900e-UNIVERSALK9-M), Version 15.2(1)T1, RELEASE SOFTWARE (fc1)

[Mohammed al Baqari]

From CUCM, generate DNA report by dialing the number you dial from missed calls

[Wilson Samuel]

Hi,

I just did resolve the same issue for a customer by using Calling Party Transformation Pattern with the Mating Calling Party Digits with wildcards and then Pre-Fix your dial-out prefix and  assign that Calling Number Transformation Pattern to your SIP Trunk (Incoming Calling Party Transformation Profile)

I have also assigned Calling Transformation Pattern on the Phones to Remove the same digits For the display of any incoming calls .e.g Any Incoming Calls on the Phone will display as

 603-555-9407 (because callers in my case were getting confused if they see as the Display as 81-603-555-9407).

However, when they see the missed calls, they see as 81-603-555-9407

HTH

[ray2mba]

wilson, can you share the screenshot of the trunk and the ph where you applied this setting?

[Wilson Samuel]

Sure if it helps.

Please find the Transformation Patterns assigned to TRunk and Phone  respectively.

HTH

[ray2mba]

great, will try your setting ans see how it goes.

[ray2mba]

thanks a lot Wilson, I did do what you did and it works.