06-03-2017 02:08 AM - last edited on 03-25-2019 08:43 PM by ciscomoderator
I have two CUCM servers,one Publisher and one subscriber.
Pub+Sub--->VG--->PSTN
when two CUCMs are working,and all ip phone were are registered to Publisher,I can make a call from the voice gateway and matched destination-pattern 96T, but when i disconnect Publisher,all ip phone are registered to Subscriber,when i made the same call from the voice gateway again,it doesn't match destination-pattern 96T.
Calling number:674 Called number:96008615989015194
I don't know why,can somebody figure it out?
06-03-2017 06:26 AM
As per the debugs shared, I can see below
Working Call :-
Incoming Dial-peer selected is 0 [Default DP]
Outgoing Dial-peer selected is 100 [Pots]
Faulty DP call :-
Incoming Dial-peer selected is 0 [Default DP]
Outgoing Dial-peer selected is 20217
Try to make the changes in VOIP DPs or create new one for incoming called-number . or 9T , to make sure that default Dial-Peer 0 is not selected.
Regards
Abhay
06-04-2017 07:37 PM
Thanks Abhay,i will try it.
Best Regards,
Mai
06-05-2017 02:15 AM
Hi Xiang,
As pointed by Abhay, the failed scenario is matching Outgoing Dial-peer 20217. 20XXX dial-peers are usually the virtual dial-peers created for sccp phones by CME/SRST. Can you also provide us the output of "show dial-peer voice summary" when the call is failing and hitting this dial-peer to see where this is routed.
HTH
Rajan
Pls rate all useful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide