Digital Link With CME

[robert.bernal]

Hello, I have one digital link configured on a Controller e1,

My carrier askme to change ANI digits, to forward calls to PSTN

Heres my Conf.

controller E1 1/0

framing NO-CRC4

ds0-group 1 timeslots 1-15,17-31 type r2-digital r2-co ani

cas-custom 1

country telmex

category 2

answer-signal group-b 1

!

!

voice-port 1/0:1

!

dial-peer voice 10 pots

destination-pattern T

direct-inward-dial

port 1/0:1

forward-digits all

How can i change Ani digits to pass it to my Carrier ISP on Cisco Callmanager eXPRESS

Regards.

[robert.bernal]

By the way

default Ani number is the CCME Extension i see it on debug, when i recive digits on debug

I need to change Ani to 40005000

thanks

[paolo bevilacqua]

Hi,

not difficult. On the DP used for outgoing calls, configure "clid network-number ".

Hope this helps, please rate post if it does!

[robert.bernal]

thanks let me try

Regards