Does anyone have an example config for a sip trunk at remote site and with Call Manager at the main site?

[Matthew Michaluk]

Hello all,

Does anyone have a example config for a remote site with a sip trunk and the main site has the call manager version 7.1.5.  The sites are communicating via MPLS.  Any help would be greatly appreciated.

[lusandi]

Hello Matthew,

From the description I see that you have a CUCM on the HQ site, but can you confirm me which device do you have at the remote office.

Regards,

Luis Sandi

[Matthew Michaluk]

cisco 2811

[Payal Bhaduri]

Hi,

These are the steps for the sip trunk configuration:

Table 41-7 Trunk Configuration Checklist

Configuration Steps		Procedures and Related Topics
Step 1	Create a SIP profile (optional). Create a SIP trunk security profile (optional) Create a SIP trunk. Configure the destination address. Configure the destination port.	Configuring SIP Profiles, Cisco CallManager Administration Guide Configuring a Trunk, Cisco CallManager Administration Guide Trunk Configuration Settings, Cisco CallManager Administration Guide
Step 2	Associate the SIP trunk to a Route Pattern or Route Group.	SIP Route Pattern Configuration, Cisco CallManager Administration Guide Route Group Configuration, Cisco CallManager Administration Guide Route List Configuration, Cisco CallManager Administration Guide
Step 3	Configure SIP timers, counters, and service parameters, if necessary.	Service Parameters Configuration, Cisco CallManager Administration Guide. For specific configurable values, see SIP Timers and Counters.
Step 4	Reset the SIP trunk	Configuring a Trunk, Cisco CallManager Administration Guide

The destinatnation port and address will be the router in the remote site.

The link below will help you with the configuration.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/5_0_1/ccmsys/a08sip.html#wp1126527

[Matthew Michaluk]

Thank you.  Do you have any configs for the router?