cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1110
Views
0
Helpful
7
Replies

E1 flap

Ahmed Yassin
Level 1
Level 1

Dear all,

E1 flap during the past last 3 weeks, and you recommended me this command:

network-clock-select 1 E1 0/1/0

It looks good as this command made 0 Slip Secs & 0 Errored Sec.

But, E1 still flap again, if i can increase the priority again from 1 to 8 or it will do nothing and if so, no other recommendation can be done from my side.

7 Replies 7

paolo bevilacqua
Hall of Fame
Hall of Fame

How many flaps?

How your E1 cable is made ?

E1 cable is 2 pairs and made from 3 years ago from starting of E1 service.

It working but suddenly down then up again at the same moment. So, any call will be terminated.

I am talking about the command shown aboe, if i can increase the priority or no.

I was asking: how many flaps do you have each day ?

Changing priority doesn't make a difference.

E1 flaps rondomly, may be a lot per day and may be few.

But, occurs during any exist call which make it down.

Please, find attached E1 debug.

Appreciated

Hi,

Do a clear counters and then sh int serial 0/1/0:15 after about an hour...post the results.

I did a clear counters.

Then sh int serial 0/1/0:15 after about an hour attached.

Open a ticket with telco.

They will say that everything is OK, at which point you will have to ask for diagnostic equipment be put inline.