11-10-2009 01:26 AM - edited 03-15-2019 08:25 PM
Dear all,
E1 flap during the past last 3 weeks, and you recommended me this command:
network-clock-select 1 E1 0/1/0
It looks good as this command made 0 Slip Secs & 0 Errored Sec.
But, E1 still flap again, if i can increase the priority again from 1 to 8 or it will do nothing and if so, no other recommendation can be done from my side.
11-10-2009 07:54 AM
How many flaps?
How your E1 cable is made ?
11-11-2009 12:43 AM
E1 cable is 2 pairs and made from 3 years ago from starting of E1 service.
It working but suddenly down then up again at the same moment. So, any call will be terminated.
I am talking about the command shown aboe, if i can increase the priority or no.
11-11-2009 12:24 PM
I was asking: how many flaps do you have each day ?
Changing priority doesn't make a difference.
11-12-2009 12:30 AM
11-12-2009 03:15 AM
Hi,
Do a clear counters and then sh int serial 0/1/0:15 after about an hour...post the results.
11-12-2009 04:38 AM
11-13-2009 06:44 AM
Open a ticket with telco.
They will say that everything is OK, at which point you will have to ask for diagnostic equipment be put inline.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: