03-14-2017 07:52 AM - edited 03-17-2019 09:48 AM
Hi, we have a problem with early media.
We changed the connection between cucm and gateway from H323 to SIP.
Now the customer tells us, that there is a PSTN number which played an announcement about the costs of this call. This worked with H323.
SInce we changed it to SIP, we dont get this announcemen.
To be honest, i really dont know much about early media.
Attached you see the isdn q931 debug.
As is understand, this:
Progress Ind i = 0x8488 - In-band info or appropriate now available
should indicate, that there is early media available.
Is this correct?
If there is early media, i dont know how to transfer this information via SIP to CUCM.
Does anybody know how to solve this?
Best Regards
Daniel
Mar 14 11:18:57 CET: ISDN Se0/0/0:15 Q931: TX -> SETUP pd = 8 callref = 0x24EF
Sending Complete
Bearer Capability i = 0x9090A3
Standard = CCITT
Transfer Capability = 3.1kHz Audio
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA98383
Exclusive, Channel 3
Progress Ind i = 0x8183
SEISR1(cfg-translation-rule)# - Origination address is non-ISDN
Calling Party Number i = 0x0180, '289XXXX'
Plan:ISDN, Type:Unknown
Called Party Number i = 0x81, '199XXXX'
Plan:ISDN, Type:Unknown
Mar 14 11:18:57 CET: ISDN Se0/0/0:15 Q931: RX <- CALL_PROC pd = 8 callref = 0xA4EF
Channel ID i = 0xA98383
Exclusive, Channel 3
SEISR1(cfg-translation-rule)#
Mar 14 11:18:58 CET: ISDN Se0/0/0:15 Q931: RX <- PROGRESS pd = 8 callref = 0xA4EF
Progress Ind i = 0x8482 - Destination address is non-ISDN
Progress Ind i = 0x8488 - In-band info or appropriate now available
SEISR1(cfg-translation-rule)#
Solved! Go to Solution.
03-14-2017 11:12 AM
Sounds like the issue is with PRACK. Enable PRACK on SIP Profile used by the SIP trunk in CUCM and on your CUBE.
03-14-2017 07:23 PM
This below link might help
https://supportforums.cisco.com/discussion/12707416/early-media-enabledisable
Find this non cisco link helpful too for understanding
https://www.dialogic.com/webhelp/IMG1010/10.5.3/WebHelp/isdn_callproceed_sip183_iw.htm
Find the below link to enable Send PRACK for all 1xx Messages from the SIP Rel1XX Options drop-down list
http://www.cisco.com/c/en/us/support/docs/voice/session-initiation-protocol-sip/116086-configure-cube-cucm-sip-00.html
You can collect debug isdn q931 and ccsip messages for the same call and post it here so if the issue still exists.
HTH
Regards
Abhay
Rate all helpful posts !!!
03-14-2017 11:12 AM
Sounds like the issue is with PRACK. Enable PRACK on SIP Profile used by the SIP trunk in CUCM and on your CUBE.
03-15-2017 05:52 AM
Thank you very much for this information, it worked immidiatly.
03-14-2017 07:23 PM
This below link might help
https://supportforums.cisco.com/discussion/12707416/early-media-enabledisable
Find this non cisco link helpful too for understanding
https://www.dialogic.com/webhelp/IMG1010/10.5.3/WebHelp/isdn_callproceed_sip183_iw.htm
Find the below link to enable Send PRACK for all 1xx Messages from the SIP Rel1XX Options drop-down list
http://www.cisco.com/c/en/us/support/docs/voice/session-initiation-protocol-sip/116086-configure-cube-cucm-sip-00.html
You can collect debug isdn q931 and ccsip messages for the same call and post it here so if the issue still exists.
HTH
Regards
Abhay
Rate all helpful posts !!!
03-15-2017 05:52 AM
Thank you very much for this information, it worked immidiatly.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide