Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hello, before to begin I thank you for your precious support in advance. we have some slowness in a branch site, a L2/L3 switch is connecting to 10 WS-C2960-48PST-L access switches connected to users phones and PCs (pc's are connected to phones) , 4...
Hi, I have Cisco 7965 phone. I am facing the error on it as attached. How I can get rid of it? BR Abdul Karim
Hello, When users decline a call , this call is forwarded to Unity Connection. For Users witch have a voicemail, call is routed to user's voicemail. For Users witch do not have voicemail , CUC play Greeting "Hello From a touchtone telephone". We wo...
Hi, I configured Traffic shape on Catalyst3650, but I cannot see the status of traffic shaping. I cannot find "show command" related to traffic shaping. ( I found"show traffic-shape" command, but it doesn't display ) Can you tell me how to confirm...
Hi Cisco Community, Can you please help me on this matter? I am currently try to upgrade a CP 7965G with a current firmware is SCCP45.8-3-2S. I tried different firmware like SCCP45.9-3-1-1S, SCCP45.8-3-3S and SCCP45.8-3-2S but still no outcome. Ki...
I have a really strange issue... I have a 7937G registered with CUCM 10.5 and it has no dial tone. However, everything else works - it shows as off-hook when I press the green button, I can dial other handsets (or external numbers) and the speaker/m...
When I try to run a DNA on CUCM 11.5 I receive an error page. I've searched Cisco documentation and can't find the proper restart procedures. When I look in the Control Center Feature page, it shows the following in service: Cisco Dialed Number Anal...
For any version of CUCM ... I have to log into multiple versions of CUCM GUIs to do MACDs, etc. They are behind NAT, so the address I go to in my browser isn't their real IP, it's the NAT'ed IP. I want to be sure I am making changes to the publish...
Expansion module is detected by 8851 but unable to configure it on cucm snap attached
Hi guys, I am setting up the box2box redundancy by following this Cisco document https://supportforums.cisco.com/sites/default/files/legacy/7/3/0/128037-CUBE_ASR_HA_Application_Note_pamistry_v2.docx I just have a few questions about the redundancy li...
We had an outage last week that turned out to be the fault of out service provider. But it caused us to do some testing of the the Subscriber server to make sure it would take over in the event of a Publisher failure. Turns out it the Subscriber will...
Downloaded the Device Package 9.1(2) to support 8821 Phones. Everything went as planned and phones are now working. However, when I go into the Device Defaults it is blank on Load and Inactive Load info. The phone is registered with the following: A...
Hi, We have a hosted WebEx with Cisco. We also have Cisco ExpressWay Edge/Core. Our problem is that we cannot make our Cisco Video Endpoints(SX20 and Cisco 9971) join the WebEx via audio and video. We have observed that it will be momentarily connec...
HelloI have a router 2900 series but that does not have the command of telephony service!I have to change the ios of the router or the router 2900 series does not support voice configuration
Hi everyone, I have a standalone PLM 11.x within a CSR 11 environment. Even though PLM can monitor the number of UCL licenses in use, I don't receive any event within PCA (Prime Collaboration Assurance) let alone an alarm. The License usage tab unde...
