06-10-2014 12:36 AM - edited 03-16-2019 11:03 PM
Hello everybody.
I have two different infraestructures in my telephony network.
One Cisco, with one publisher, a suscriber and two voice gateways, one of them connected with a Nortel CS-1000 PBX by a QSIG.
When I try to do a conference between a Cisco and a Nortel, the Nortel phone leaves the conference itself.
Between Cisco phones, there is no problem.
Can anybody help me?.
Thanks in advance
06-10-2014 01:14 AM
How do you integrated Cisco with Nortel ? Which protocol ?
Does the Trunk/GW between Cisco and Nortel contains CFB in its MRGL ? Which all codec are in use when you do conference ?
If there is mismatch in codec then you need Xcoder for this.
06-10-2014 02:44 AM
Hello!
'one of them connected with a Nortel CS-1000 PBX by a QSIG..'using E1/T1? If yes, try to use 'debug isdn q931' to see, who sends release message. If it goes from CUCM, then go through steps that Manish has suggested.
Regards,
Kirill
06-10-2014 12:24 PM
Attach CallManager traces for one of these calls.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide