cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

744
Views
0
Helpful
2
Replies
Highlighted
Beginner

Free Source Softphones Problem

Hi,

I'm trying to configure various free source softphones (linphone, ekiga and jitsi) to a cucm, but all of them failed. My question is, how can i configure an account to make them work properly.

While trying to see what fails in wireshark, it says that it can't find the account.

 

Thanks.

Everyone's tags (3)
2 REPLIES 2
Highlighted
Cisco Employee

 Hello There are many

 

Hello

 

There are many information available on search how to configure 3rd SIP endpoint with CUCM. Below are docs describer how to configure the same.

http://www.netcraftsmen.net/blogs/entry/sip-endpoints-in-cisco-cucm-x-lite-as-an-example.html

http://www.markholloway.com/blog/?p=1111

http://novtel.wordpress.com/2011/07/08/sip-endpoints-in-cisco-cucm-x-lite-as-an-example/

 

Br,

Nadeem

 

Br, Nadeem Please rate all useful post.
Highlighted
Advocate

Hi Mate,I had tried jitsi in

Hi Mate,

I had tried jitsi in past while testing something. I was able to register it to CUCM.

 

1) Created End user

2) Setup Digest credentials on the end user page(used by SIP client)

3) Created a basic third part SIP device in CUCM with a dummy mac address.

4) Assigned extension etc. and did setup DIGEST USER on the phone config to the user created in step 1

5) Associate the device to end user

 

from jitsi:

1) Add account> SIP ID: extension@1.1.1.1 (where 1.1.1.1 was my primary subscriber not Pub)

2) Pwd: Digest Credentials set above

3) Advanced>Connection>Authorization name: userid of the end user created in step1

 

This is what had worked for me

 

-Terry