Free Source Softphones Problem

[noeltello]

Hi,

I'm trying to configure various free source softphones (linphone, ekiga and jitsi) to a cucm, but all of them failed. My question is, how can i configure an account to make them work properly.

While trying to see what fails in wireshark, it says that it can't find the account.

Thanks.

[Nadeem Ahmed]

Hello

There are many information available on search how to configure 3rd SIP endpoint with CUCM. Below are docs describer how to configure the same.

http://www.netcraftsmen.net/blogs/entry/sip-endpoints-in-cisco-cucm-x-lite-as-an-example.html

http://www.markholloway.com/blog/?p=1111

http://novtel.wordpress.com/2011/07/08/sip-endpoints-in-cisco-cucm-x-lite-as-an-example/

Br,

Nadeem

[Terry Cheema]

Hi Mate,

I had tried jitsi in past while testing something. I was able to register it to CUCM.

1) Created End user

2) Setup Digest credentials on the end user page(used by SIP client)

3) Created a basic third part SIP device in CUCM with a dummy mac address.

4) Assigned extension etc. and did setup DIGEST USER on the phone config to the user created in step 1

5) Associate the device to end user

from jitsi:

1) Add account> SIP ID: extension@1.1.1.1 (where 1.1.1.1 was my primary subscriber not Pub)

2) Pwd: Digest Credentials set above

3) Advanced>Connection>Authorization name: userid of the end user created in step1

This is what had worked for me

-Terry