07-06-2015 05:32 AM - edited 03-17-2019 03:32 AM
Hi guys,
I got 16 analogue lines from Service provider and I need to connect them to my FXO ports, my question is how to terminate them with RJ11? one pair per each line and how can I know if my termination is good from inside the Gateway?
Thanks,
Saeed
Solved! Go to Solution.
07-06-2015 05:49 AM
Hello mohammad,
RJ11 will use pins 3 & 4.
Link below shows the pin out for RJ11
http://www.allpinouts.org/index.php/RJ11_Telephone
To verify your RJ11 wiring, plug the RJ11 into an analog phone and go off hook. Hear dial tone, you know you are good. Plug the RJ11 into the fxo port.
See document below for troubleshooting Analog voice interfaces.
Hope this helps.
Please rate helpful posts.
Thanks.
07-06-2015 05:49 AM
Hello mohammad,
RJ11 will use pins 3 & 4.
Link below shows the pin out for RJ11
http://www.allpinouts.org/index.php/RJ11_Telephone
To verify your RJ11 wiring, plug the RJ11 into an analog phone and go off hook. Hear dial tone, you know you are good. Plug the RJ11 into the fxo port.
See document below for troubleshooting Analog voice interfaces.
Hope this helps.
Please rate helpful posts.
Thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide