cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

135
Views
0
Helpful
2
Replies
Highlighted
Beginner
Beginner

FXO TRUNKGROUP not bypass fxo port if the line is disconnected

Dears

we face this issue , we have VG with 8 FXO ports used for PSTN calls , all these ports members of TRUNK Group which used for outside calls .when we  unplug the cable from line 1 and place an outbound call, it tries to go out of line 1 and I get a busy signal and call not try to go out through second line which has cable connected


we try these settings but same issue

voice-port x/x/x

cable-detect

!

 

How can we set the router up to bypass that port if the line is disconnected with out shut this port administratively ?

Everyone's tags (1)
2 REPLIES 2
Highlighted
Cisco Employee

Re: FXO TRUNKGROUP not bypass fxo port if the line is disconnected

Add "max-retry 5" under the trunk group and then test.

Nipun Singh Raghav
"We cannot solve our problems with the same thinking we used when we created them"
Highlighted
Beginner
Beginner

Re: FXO TRUNKGROUP not bypass fxo port if the line is disconnected

Hello Nipun Singh Raghav
unfortunately ,issue not fixed after applying this command . do have any other work around tested successfully  ?