FXS port from UCM 8.5

[angel-moon]

Hello,

If running UCM 8.5 and I have an H.323 gateway (a 2900 series router with an FXS card) what do I need to do on CM (and possibly on the router) to route a number out of one of the FXS ports?  A paging system is plugged into the FXS port so the end result would be that a users dials the paging number and gets access to the paging system.

Thanks in advance!  All replies rated.

[Jaime Valencia · Accepted solution]

On CUCM regular H323 config (GW pointing to the IP) and a route pattern pointing to it.

In the H323 config the pots dial peer pointing to that port so it's routed to the FXS.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk