cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

347
Views
0
Helpful
3
Replies
Highlighted

Gateway of CUCM8.5 on UCS C210M2 issue

Hi everyone,

I'm fresh installation CUCM 8.5 in ESXi4 (UCS C210M2 model). And we are facing CUCM system unble to ping or trace route to local network, although we are configure static IP address including gateway completed. So, we are confuse what is the cause of this problem between CUCM system or ESXi4 and how to fix it. I would ask on here to see if anyone  else has had a chance to test or fix this  out. 

We try to logging in CLI of CUCM system for seting the network interface down and up again, but still not working.

Thanks.
Everyone's tags (3)
3 REPLIES 3
Hall of Fame Cisco Employee

Gateway of CUCM8.5 on UCS C210M2 issue

If you can't ping it's either a problem with the VSS you configured in ESXi, your switch config or simply routing/ intervlan routing.

There's really no way to tell you where your problem is with just that info.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

Gateway of CUCM8.5 on UCS C210M2 issue

Hi

We just configure simply routing and any VLAN routing. We don't know why is not able to route within local network.

Thanks.

Cisco Employee

Gateway of CUCM8.5 on UCS C210M2 issue

Hello Piyachat,

To start with check out the following configuration

Is your CUCM IP address is in same subnet as ESXi vmkernel address ?

If not, have you configured appropriate VLAN ID for the port group on  vSwitch in ESXi host ?

Does your upstream physical switch port allows necessary VLANs ?

Padma

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here