Gathering files via CLI for Cisco Call Manager 11.5

[kwajmahall]

i guys, do any of you know the CLI commands for me to get a file from my CUCM to my FTP server?  My TAC engineer is on his off hours.  He asked me to run this command:

utils network capture eth0 file packets count 1000000 size all

That is straight forward enough, but what will be the name of the file where these packets will get collected and how exactly do I FTP it to my FTP server?  Also, is there a command to turn the packet capture off or does it automatically turn off after it reaches 1000000?

I hope this makes sense, thank you in advance. Any assistance is appreciated.

[Chris Deren]

Here is are good write ups on it:

https://community.cisco.com/t5/collaboration-voice-and-video/packet-capture-on-cucm-appliance-model/ta-p/3118507

https://www.jasonneurohr.com/articles/cisco-unified-communications-manager-packet-capture

[Anthony Holloway]

If you issue the command: utils network capture ?, It will tell you where and how to get the file.