H323 Gateway/FXO ports

[aaron.banks11]

I have a couple of questions about configuring FXO ports in an H323 gateway.

1.  For every voice port I use, do I need dial peers for each individual port?  So...voice port 0/0/0 - has a 911 dial peer, local, LD, international.  And same for the second voice port, so if I have 4 voice ports and the above mentioned dial peers, that would be a total of 16 dial peers (for argument's sake).  Or is there a better/more efficient way of doing it?

2. Other than adding the gateway in call manager, is there anything else?  i.e. do I need to add a separate gateway for the FXO ports?  I don't believe so, but I have to ask since I don't normally configure H323 gateways.

Thanks taking the time to answer :)

[Jaime Valencia]

1 https://supportforums.cisco.com/discussion/10436306/configuring-fxo-port-trunk-group

2 No, you just need the GW as H.323 on CUCM to route to it, then the GW needs the config for call routing as well.

[aaron.banks11]

Thanks Jaime!  That link makes perfect sense.