01-10-2011 12:32 AM - edited 03-16-2019 02:46 AM
Hi,
I have been testing a fxs port within cisco 2600..The signal is gound start.
Since I have rebooting C2600, but a phone not received a dialtone.
But I have changed signal for loop start and I have rebooting C2600...As a result, a phone received a dialtone.
Please tell me what the reason.
Analog Phone - c2600 with fxs ~~ c2600 with fxs - Analog Phone
01-10-2011 05:02 AM
The reason is that telephones only use Loop Start, but never Ground Start.
01-10-2011 06:17 AM
Paolo,
Your quite correct regarding the use of Loop Start for POTS phones, my thoughts as to why the reload stopped the calls working were that the port had been reconfigured as ground start, but the port had not been shut and unshut after the config change. This may have masked the impending issue and caused the perceived failure after reload.
Craig
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide