Hotline configuration with IP Phone on CME

[nguyendd]

Hi all,

I would like to configure hotline feature between two IP phones on CME. When I go off-hook one phone, the other will ring, user just pick up and answer the call. My company use SIP and SCCP also, so please advice me the command to archive this feature.

Thank you very much

[Carlo Poggiarelli · Accepted solution]

Hi.

Do what follows

ephone-dn 1 <-- this is the line where the call starts from

number 1000

intercom 2000 barge-in

ephone 1 

button 1:1

autoline 1

In this case phone with extension 1000 will go off hook and dial 2000 immediately

HTH

Regards

Carlo

[nguyendd]

Hi Carlo,

Thanks for your reply, how about SIP configuration? Cause, my company use both SIP and SCCP.

Thank you

[daniel.tang1]

I have same problem. can you share me how to configure the SIP phone?

Best Regards,