how to change the status of "DisplayOnIfIncomingCall" to on

[oracat777]

hi all

I have make some CP7975 to register to the CME (C2921 IOS Version 15.1(3)T),

after that, I found the phone can not go to the power save mode automatically, so I configured those commands,

telephony-service

service phone displayIdleTimeout 00:01
service phone displayOnDuration 00:10
service phone displayIdelTimeout 00:10
service phone daysDisplayNotActive 1,7

and now the phones can go to the power save mode automatically after some inactive timer.

but now I find other problem, phones can not Display on while a call is coming, I look for the cisco.com and google it, but got nothing about it. I can not find the command to change the status of the phone from disable to enable.

so can anyone can help me or give me some advice?

thanks in advance !!!

[Rob Huffman · Accepted solution]

Hi Yu,

Here we go

displayOnWhenIncomingCall {0 | 1}

Enables and disables an IP phone display to be activated when an incoming call is received (Line state is Ring in). The display will switch off again once the ringing stops if the user has not touched the phone and if the phone display is supposed to be off. •0—Disabled (default). •1—Enabled. Note This parameter is not supported in ephone-template configuration mode.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/command/reference/cme_s1ht.html#wp1137696

Cheers!

Rob

[oracat777]

hi Rob,

you are so NICE, i will try it, +5 for you .

thanks.

yu.