cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
356
Views
5
Helpful
1
Replies
Highlighted

How to register Alcatel 4038 with CUCM 11.5

Hello everyone,

 

I'm trying to register an Alcatel SIP phone to CUCM, but I didn't succeed on it, I get the message "No TFTP response" on the phone. Phone and digest credentials are already created in CUCM

 

I found a "SipConfig.txt" that I should upload to the phone via TFTP with the SIP configurations, but it still didn't work.

 

Has anyone already done this configuration?

 

Regards!

1 REPLY 1
Highlighted
VIP Rising star

Yes, this is applicable. You may check the following post: https://community.cisco.com/t5/ip-telephony-and-phones/register-alcatel-ip-phone-4018-with-cucm-9-1/td-p/2608897

 

Have you fully followed the procedure of adding a 3rd Party SIP phone on the CUCM?

G

Please Rate Posts (by clicking on Star) and/or Mark Solutions as Accepted, when applies
Content for Community-Ad