cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
961
Views
0
Helpful
1
Replies

I am unable to enable TLS on my Cisco gateway

glennkaczor
Level 1
Level 1

I try to follow the instructions in the Cisco documentation for configuring to use TLS, but neither the "crypto signaling" command under sip-ua nor the "session transport tcp tls" (either under voice services voip sip or in a dial peer command) are available.  What might I be missing to make these commands available so I can use TLS?  I am running "c2800nm-ipvoicek9-mz.150-1.M4.bin" version of the IOS, and all my configuration occurs via CLI on the gateway.

1 Reply 1

acampbell
VIP Alumni
VIP Alumni

Hi,

In order to provide SIP Gateway support for TLS you need to use the "SPSERVICES" featureset in the IOS.

Cisco have also pulled support for your IOS version due to multiple bugs

You should upgrade 15.0.1.M7 -SPSERVICES

You will need 128M of flash & 512 M DRAM

HTH

Alex

Regards, Alex. Please rate useful posts.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: