06-28-2022 11:00 AM
Hello Everyone,
My Customer has a CME installed under Cisco ISR 4431, this router contains two interfaces BRI,
we have configured the all the Features, everything work properly, one single point, is when we make a call from PSTN to Internal using BRI Interfaces, the doesn't rings on the IP Phone that specified to receive External Calls
when I debug using "debug voice q931", I can see nothing on the Terminal
Could you please help me for this issue ?
06-28-2022 12:04 PM - edited 06-28-2022 12:13 PM
Please share your running configuration.
If you don’t get any output from the debug and you have turned on term mon and have not turned off terminal logging in configuration it would indicate that the call is not reaching the gateway. Are you sure your calling to the correct number? If you are you’ll need to reach out to your provider to check with them why the call doesn’t get sent into you.
06-28-2022 03:09 PM
07-06-2022 02:43 AM
Echoing Roger's comment, if the call isn't appearing in "debug isdn q931" then the CME can't do anything to route it.
Are the BRI interfaces all properly up (show isdn status)?
Layer 1 should be ACTIVE and Layer 2 MULTIPLE_FRAME_ESTABLISHED
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide