Interconnection PABX to Cisco E&M Card

[Fernaldy Fernaldy]

Hi,

I have a problem connection between PABX (Nortel Meridian Option 11C with Voice Gateway 4431 E&M Card, I want to ask should I need to config on PABX or configure on Voice Gateway or it's wiring cable problem?

My PABX Wiring cable (White, orange, white, blue, white green, white brown) and use rollover cable to VG.

I also attached my debug voice from my Voice Gateway.

Please help...

Thank you,

Regards,

Fernaldy

[R0g22]

What will you use this connection for ? Calls, MOH etc ? Add a "show version" and "show run" from the ISR-4k ?

[Fernaldy Fernaldy]

Hi Nipun.

I will use SIP Trunk on CUCM to connect the E&M.

Thank you

Regards,
Fernaldy

[Fernaldy Fernaldy]

Hi Nipun.

I will use SIP Trunk on CUCM to connect the E&M.

Thank you

Regards,
Fernaldy

[R0g22]

Does not make sense sir. You are talking about two different things here. You cannot connect an IP protocol to an analog port directly. You would be terminating SIP trunk from CUCM to GW. GW will connect through E&M to ????