cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
375
Views
9
Helpful
3
Replies

Internal conf fails

miket
Level 5
Level 5

Has anyone seen a conference between three 7945G internally fails.  When you hit conf to join the third phone it drops the call

All sccp. Cucm 8.6.2. Phone form 9.2.1

I have never seen a conference fail. Etween three internal calls

Thoughts?

3 Replies 3

Hi,

If you create MRGL, make sure the phone that create the conf is assigned this MRGL

Or leave all resources out of any MRG

Regards

Haitham

Manish Gogna
Cisco Employee
Cisco Employee

Check the device pool / region settings between the three phones. If they are all talking g711 to each other then software conference bridge should allow the conference call. Make sure that the confrence bridge is registered and assigned to MRGL of the phones. If g729 codec is involved by any chance then you need a transcoder or a hardware conference bridge in the MRG of the phones. If all of the above is in place then try restarting the IP Voice media streaming app service.

HTH

Manish

Thanks guys. Issue was Advertise G.722 was turned on , I had turned off due to some issues with Contact Center and somehow got turned back on.

Thanks Guys

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: