Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
4498
Views
5
Helpful
16
Replies

Internal MOH

Go to solution
mightyking
Level 6
Level 6

‎09-06-2011 02:11 PM - edited ‎03-16-2019 06:51 AM

Hi All,

Our external MOH works but internal fails. The wav file is being played from the GW. I am using 239.2.1.1 as the Base Multi-cast IP Address because one of our SUBs is sourcing the MOH. I am using the same address under Call-Manager-Fallback. Could you please let me know if I am missing anything in the config.

Thanks,

MK

Labels:
0 Helpful
16 Replies 16

Go to solution
mightyking
Level 6
Level 6
In response to William Bell

‎09-13-2011 07:20 AM

Hey Bill,

A quick question for you. Under Call-Manager-Fallback, I am using the loopback0 IP address for the MOH. The ip pim sparse-mode command is configured under loopback0 interface. The show ip pim neighbor shows only the IP address of the loopback0 interface. I was wondering if that could be the issue for my internal MOH.

Thanks,

MK

0 Helpful

Go to solution
William Bell
VIP Alumni
VIP Alumni
In response to mightyking

‎09-13-2011 07:29 AM

No, I don't think so. I would think that you would be streaming MoH to internal hosts from your CUCM.

Regards,

Bill

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

0 Helpful
Customers Also Viewed These Support Documents