IP Phone and Analog same DN

[Toss Leey]

Hi

I am not expert in CME, I have IP Phone and ATA connect to analog phone with same DN 200, but the problem is when someone dial 200, sometime IP Phone ring and sometime Analog Phone ring, How i can make both phones ring in same time.. Here is snapshot for Config.

voice register dn  200
 number 333
 no-reg

voice register pool  1
 id mac D0D7.9914.CC3F
 type ATA-187
 number 1 dn 200
 number 2 dn 200
 

ephone-dn  200 dual-line
 number 200
 call-forward noan 40 timeout 30

ephone  200
 device-security-mode none
  mac-address 44BB.D9CC.AD65
  type 3905
  button  1:200

Thank you

[Mohammed al Baqari]

Hi,

Based on the config you shared, the ATA will never ring because it has a DN of 333 while the ephone has a DN of 200.

To achieve what you want, you can create voice hunt-group with DN of 200 and assign both IP Phone and ATA to it.

Look at Cisco document to create voice hunt group.

http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/admin/configuration/guide/cmeadm/cmecover.html#pgfId-1118310

[Toss Leey]

Hi

Actually DN for ATA it have same DN as IP Phone, but I typed here wrongly

voice register dn  200
 number 200
 no-reg

Thank you

[Tagir Temirgaliyev]

I had problem like this

sip and sccp phones when connected to cme dont ring together

but when connected to cucm they do

[Mohammed al Baqari]

Try the work around I suggested. Create a voice hunt group and assigned both DNs to it and test.

http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/admin/configuration/guide/cmeadm/cmecover.html#pgfId-1118310