Is a VG320 supported with Cisco ISR 4331 (CME)

[FRANZ EDUARD PETERMANN]

Hello!

I can not find a matrix for CME where a VG320 is supported with CME on a ISR 4331 or maybe I'm blind.

Requirements are 6 FXO and 30 FXS
Since the Cisco ISR 29xx are EOS "soon" I would like to use a Cisco ISR 4331 (CME 11.6) and a VG320 with SCCP.

Cisco Unified CME 11.6 Supported Firmware, Platforms, Memory and Voice
http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/requirements/guide/cme116spc.html

There is only the VG350 listed and so I’m not sure if this will work also with a VG320.
I guess yes but I would feel better if there is document from Cisco where it is confirmed.

Best regards
Franz

[Rob Huffman]

Hi Franz,

Check out Table 2 in the attached link. The VG320 is supported with CME 9.0 and later;

http://www.cisco.com/c/en/us/products/collateral/unified-communications/vg-series-gateways/product_data_sheet09186a00801d87f6.html

Cheers!

Rob

[FRANZ EDUARD PETERMANN]

Thanks for your answer Rob, still not tested it but I think it will work.