11-25-2007 03:27 PM - edited 03-15-2019 07:25 AM
What would be the correct Hardware to connect:
AN E1 ISDN Connection to be terminated on a HDSL modem and then to a CIsco Router - WIC-2MFT-G703/WIC-2MFT-E1 OR Cisco E1/T1 ISDN PRI Network Module or something else???
11-25-2007 05:06 PM
Hi, which router model do you have ?
11-25-2007 05:14 PM
3845 running IOS 12.11(T)
11-25-2007 05:50 PM
Hi, if no PVDM2-xx in the box (do show diag to know), you need VWIC-1MFT-E1 or VWIC2-1MFT-1E1/T1, and a PVDM2-32 to support full 30 channels, or a smaller PVDM2 size like 16 or 8.
Thanks for the rating and good luck!
11-25-2007 09:08 PM
yes, there is a PVDM2-64 installed, will a VWIC-2MFT-G703 work for this as well?
12-02-2007 09:07 PM
Will a VWIC-2MFT-G703 work for Connection of ISDN E1 T2 Fibre line???
12-03-2007 01:23 AM
Yes. Your telco will present an E1 interface to which you connect the router.
Note, you don't need, the G.704 version that is used only when unframed is desired. The basic vwic or vwic2 is enough.
Hope this helps, please rate post if it does!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide