04-17-2012 12:15 AM - edited 03-16-2019 10:41 AM
Hello, I have some issue with calls on FXO to FXS ports when using CUCM. So, I have 6 FXO ports and 8 FXS/DID ports registered in CUCM. When I call from PSTN to one of this FXOs then after first beep, there is long beep. And only after that call happening and called party hear ring on analog phone. Is anyone know anything about this?
04-17-2012 01:44 AM
Vyacheslav,
What is the CUCM version ?
What is the gateway router model & IOS version running into it ?
GP.
04-17-2012 10:25 PM
CUCM version 6.1.4.1000-10.
Router 3825 IOS version C3825-SPSERVICESK9-M 12.4(3i)
Customer use EVM-HD-8FXS/DID with EM-HDA-6FXO
signal method is loop start on both FXS and FXO.
MGCP is used for call control.
Also there is a E1 PRI configured on a gateway.
04-18-2012 07:04 AM
Thanks. I would try tweaking the signaling on FXO port among the options available there. I guess they are Ground Start & POTS.
Pls let me know how it goes.
GP.
Pls rate the post if it helps by clicking on stars below the post !!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide