First of all appologies if this is in the wrong category, but I couldn't find a QoS category
I am studying QoS for my SWITCH exam and I am having a hardtime understanding the bits used for L3 IP Precedence and DSCP markings
The texts keep referring to left most bits of the ToS Byte but the values they are stating lead me to look at the right most bits to get the values they are referring to!
IP Precedence markings and Differentiated Services Code Point (DSCP) markings are both Layer 3 markings. IP Precedence uses the three leftmost bits in an IPv4 header's Type of Service (ToS) byte. Like CoS, with three bits at its disposal, IP Precedence markings have values in the range of 0[nd]7.
Are the three left most bits the red highlight or the blue hightlight? Example, 00101011or 00101011 (So I am asking is it the left most bits in use or just the left most bits of the byte?).
Book Extract Cont..
Again, Cisco cautions us that values of 6 and 7 are reserved, so you should mark voice media with an IP Precedence value of 5. DSCP markings use the six leftmost bits of a ToS byte, giving us 64 potential values (in the range 0[nd]63). Rather than allowing haphazard value assignments, the IETF has identified and named a collection of preselected values, called per-hop behaviors (PHBs).
How can the six leftmost bits of a ToS byte give a range of 0 - 63? Looking at a standard byte 00110011 the six left most bits would value 252 if all turned on, and the right most bits would value 64 if all turned on 00110011? Unless as asked above the six leftmost bits begin where the logical ON begins eg 00110011 in which case what would happen if the value was 00001111 as you wouldn't have six bits in play, so would the value be 15 as per the bold?
In addition to the above when referring to the Least Significant Bit are we looking at the last binary 1 (on) or the last binary digit to the right side of the byte regardless if it is a 1 (on) or 0 (off)? Example 11011011 - So the bold 1 at the right side is the least significant but, but if the byte read 11011010 would the 0 at the far right be the least significant bit or would this fall back to the next available 1 (on) bit which would be the bit highlighted in red? I suspect the digit in Red!
Thanks in advance, I know someone out there who works with QoS will be able to answer this for me!
Understanding Media Negociation in Interworking / Traversal Call : SIP <-> H323 through Expressway. Inside SDP and H245. Both signaling and Media goes through the Expressway so the IP address of expressway is offered to both SIP and H.323 endpoin...
Sometimes you troubleshoot the phone presence status issue, or you are wondering how the status is retrieved by IMP, the best place to start is to look at the SIP Publish message sent by the CUCM to IMP, Capture the SIP Publish message using wireshark, in...
The translation pattern is the most important tool in the Call Routing Process on Cisco Unified Communication manager.By definition a Translation Pattern is used to match the DIALED NUMBER (CALLED). After a match is found we perform a digits manipulation....
Sometimes, you want to populate the Self Service User ID and the Primary Extension + the Conference Now Meeting Number automatically with the IpPhone or Telephone Number LDAP Attribute used in the LDAP Directory configuration page when importing AD users ...
A Cisco 2022. május 10-én bejelentette a Webex Room család legújabb tagját a Room Bar-t. Az új eszköz a népszerű Webex Room USB/Mini kategóriájában teszi elérhetővé azokat a funkciókat, amik korábban csak a nagyobb Webex Room Kit-től felfelé voltak jellem...