cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
796
Views
0
Helpful
2
Replies

MCS7825-H3 RAM Memory upgrade

DanielGoQ_2
Level 1
Level 1

Hello experts,

We have some old MCS7825-H3 servers with 2GB RAM memory we need to upgrade to 4GB.

I was wondering if there is a particular way to perform the upgrade:

- Do we only need to power the server down and then install the modules?

- Is a particular slot assignation we need to take into consideration?

I can see that at this moment modules are installed in slots 1 and 3 (that's the original configuration).

Any suggestions or comments will be appreciated.

Thanks a lot!

1 Accepted Solution

Accepted Solutions

Jonathan Schulenberg
Hall of Fame
Hall of Fame

Yes you just have to disconnect power, follow appropriate anti-ESD precuations, and install the memory.

The large sticker on the inside of the server's cover explains how memory should be installed.

http://h18004.www1.hp.com/products/quickspecs/12572_na/12572_na.html

View solution in original post

2 Replies 2

Jonathan Schulenberg
Hall of Fame
Hall of Fame

Yes you just have to disconnect power, follow appropriate anti-ESD precuations, and install the memory.

The large sticker on the inside of the server's cover explains how memory should be installed.

http://h18004.www1.hp.com/products/quickspecs/12572_na/12572_na.html

Thanks a lot Jonathan!!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: