MGCP updates

[Forcefield]

Hi all

I need to change IP addresses for my routers for MGCP and currently I have changed the confgiurations of one of my sites.

The new configs show the updated new IP addresses but when I run show ccm-manager command I get the old IP address still registered against my primary server.

Do I need to reboot the router to get this changed or should resetting MGCP simply update the settings?

thank you in advance

FF

[Jitender Bhandari]

Hi

check for below command

mgcp call-agent XXX.XX.XX.XX 2427 service-type mgcp version 0.1

reference link below

http://www.cisco.com/c/en/us/support/docs/voice/media-gateway-control-protocol-mgcp/23966-mgcp-pri-cm.html

HTH

JB

[Jaime Valencia · Accepted solution]

Also make sure your config server is properly configured, if you have it

ccm-manager config server

And you should be able to just do a no mgcp / mgcp to get this going.