missing command - session server-group IOS XE 17.09

[Paul Austin]

Hi All, Has the command "session server-group XX" been superseded by something else? The only options I get from the dial-peer are protocol, target or transport. Cannot find anything.

This is an ISR 4321

Thanks

Paul

[Roger Kallberg]

No it has not been replaced by something else. Have you enabled licensing for voice services?

[Paul Austin]

Yes, It is currently running as a CUBE and registered with the smart account. All other commands are there.

[Roger Kallberg]

Can you please share the running configuration of the router?

[Paul Austin]

see attached. I cannot define session server-group 301 in dial-peer voice 301 voip

[Roger Kallberg · Accepted solution]

You’re missing this command on that dial peer.

session protocol sipv2

[Paul Austin]

aaaaggggggg can't believe I missed that - thanks

[Roger Kallberg]

Apart from that you don’t seem to use the version of IOS that you wrote in your initial post. Not according to the shared configuration at least.