missing pri-group command

[miket]

Has anyone seen on a 2951 ISR running IOS 15.01 , when I try to configure the controller for a pri the "pri-group timeslots| command is missing.

Any IDEAS????

[mudmathu]

Check it out, if you have specified the the card type. You need to to specify it first..

--------------------------------------------------------------------------------------------------------------

A sample config ::

config t
Card type t1 2 1

Now the controllers show up:
controller T1 2/0

controller T1 2/1

controller T1 2/0
pri-group timeslots 1-24 service mgcp
controller T1 2/1
pri-group timeslots 1-24 service mgcp

interface Serial2/0:23
isdn bind-l3 ccm-manager

interface Serial2/1:23
isdn bind-l3 ccm-manager

-----------------------------------------------------

The 2951 does support the pri-group with 15.1 IOS.