cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2665
Views
0
Helpful
4
Replies

Model TFU - 100A Bogen intergration with CUCM 8.6

Sam naik
Level 1
Level 1

Hi Team,

We did Valcom paging using FXO integration with CUCM recently and it's working fine. We are in process to intergrate another paging system Model TFU - 100A Bogen with CUCM 8.6.

I believe it would be the same procedure as Valcom, but it would be great if we get some information about the reqirement and how to setup this (Document)?

Thanks

Regards,

Sam

4 Replies 4

Rob Huffman
Hall of Fame
Hall of Fame

Hi Sam,

Every person I've ever worked with here has had to use a "mid-point" integration peice like the TAMB-2 (see link) between the FXS/FXO and Bogen

http://www.bogen.com/products/telephonepaging/index.html

Cheers!

Rob

PS: you can also use the original TAMB (google) for a cheaper co$t

"Everything is broken" - Bob Dylan

Hi Rob,

Thanks for the message. It’s seem that it have to have require “Mid Piece” device i.e TAMB2. We are planning to use FXO to Bogen. Is there any other option available with this piece please.

Thanks

Regards,

Sam

                   Thanks for the information. Appreciated

Rob Huffman
Hall of Fame
Hall of Fame

Hi Sam,

The TAMB2 or "older " TAMB both work with FXO circuits so you would be good to go These

are both pretty cheap part$ with the TAMB being the cheapest. Without this piece

you will have trouble bridging between the phone system and the Bogem Amp unless it

has a direct connect FXO/FXS capability which I doubt it does.

Station Port Compatibility: Two-wire ring start

Trunk Port Compatibility: Two-wire loop start or ground start

http://www.bogen.com/products/pdfs/telephonepagepdfs/TAMB2s.pdf

Cheers!

Rob

"Everything is broken" - Bob Dylan