MoH from local CUBE router

[MARK BAKER]

I am considering using a SIP provider for PSTN access. I have a MoH question for our HQ and our branch sites. I would like to know if anyone has these scenarios working.

1. HQ - CUCM <-> H323 <-> CUBE <-> SIP <-> ISP

Cube sourcing Multicast MoH from E&M connected external MoH player

Will MoH play through the SIP trunk to a PSTN phone when an internal IP phone places the call on hold?

2. Branch - Same as HQ except MoH comes from internal flash

Will MoH play to PSTN phone over SIP trunk?

NOTE: CUCM to CUBE protocol can be changed to SIP if necessary. Both scenarios are working now with PRI connections on gateways.

Thank you,

Mark

[MARK BAKER]

I fond a document that talks about Multicast MoH for CUBE which I new existed but am not sure if it is supported when sourced by the Cube router itself. Even though not clearly stated in this document, I would assume that CUBE can play the MMoH stream to the PSTN by converting it to unicast no matter if it came from a different source or the CUBE router itself. Has anyone done this?

Requires version 15.2(1)T and SIP to SIP CUBE from this document.

Thanks,
Mark

[Ayodeji Okanlawon]

There is an ask the expert forum been moderated by one of Cisco's SIP expert: Randy. I suggest you post this question to him. This is the link for the thread

https://supportforums.cisco.com/thread/2154873?tstart=0

Please rate useful posts

"For the love of God is broader than the measure of man's mind And the heart of the Eternal is most wonderfully kind"