07-23-2014 08:15 PM - edited 03-16-2019 11:30 PM
CUCM 10.5, 2911 router with E&M card
I understand the basics of making this work with multcast. Blocking the source from the CUCM so the phones listen to the router instead.
Does this work on MGCP? Will my E&M card work not being programmed into the CUCM? Does my voip dial-peer even work in MGCP? I did this years and years ago with an H323 srst GW but a little different setup and want to make sure before I get to far.
Solved! Go to Solution.
07-24-2014 07:22 AM
No, this does not work with MGCP, you still need to do the SRST as MOH source config + live feed config to get this.
07-24-2014 07:22 AM
No, this does not work with MGCP, you still need to do the SRST as MOH source config + live feed config to get this.
07-24-2014 07:46 AM
So I can keep the router as MGCP in CM but add SRST and it will use the dialpeer?
07-24-2014 08:24 AM
Yes
http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cusrst/admin/sccp_sip_srst/configuration/guide/SCCP_and_SIP_SRST_Admin_Guide/srst_appendix_b.html
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide