Monitor FXS active calls on 2811 with VOICE IOS

[rafik24123]

Hi All,

I have few 2811 some with an NM-HDA-4FXS and others with VIC-4FXS.

I would like to monitor the acitve calls between site but i'm unable to find the right OID.

I have tried the voice MIBs but i'm unable to get a response on most of the OIDs.

I'm able to monitor the interface throughtput

I would need to have the number of active calls or the bandwidth allocated to calls.

I looked all over the place but i cannot find anything relevant.

Could you please help.

Best Regards,

Rafik

[rafik24123]

Any hint would be highly appreciated

[rupam_chakra1983]

try the commoand " show voice call staus "

This will show you actve calls.

Rate this if found useful

[rafik24123]

Hi Rupam,

Thank you for your answer,

I've been using this command but i cannot use a script on my NMS.

I'm trying the cva iffxsstatus: #[1.3.6.1.2.1.2.2.1.2] from CISCO-VOICE-ANALOG-IF-MIB but this only tells me if the phone if onhook / offhook but

doesnt tell if a call has been initiated.

Regards,

Rafik