cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Walkthrough Wednesdays
507
Views
0
Helpful
2
Replies
Randy Haddon
Beginner

Monitoring VoIP calls

I am needing to know if there is a way to track how many calls are going out at the same time on one of our voice GWs.  I currently have a 2811XM running IOS  ver. 12.4(22)T4.

Over the last two weeks I have had to reboot the router due to the fact calls were not going through, you dial the number and then there is no dial tone no busy signal no sound what so ever.  once I reboot the router calls start going through, talked with AT&T and they said they are seeing sync errors coming from my equipment but no problems on there end.

Any ideas?

Thanks

Randy Haddon

1 ACCEPTED SOLUTION

Accepted Solutions
ronpatel
Collaborator

Hi

You can USE RTMT

1) System ---> performance ---> select the call processor --->

Select the type of gateway.

Then graph what you need like ""ACTIVE CALLS "

2) If you can only use IOS commands then

"show voice call status | i active" will show active calls.

3) Or you can use SNMP for it :- cvCallActiveDS0s  is the OID.

Regards

Ronak patel

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.

View solution in original post

2 REPLIES 2
ronpatel
Collaborator

Hi

You can USE RTMT

1) System ---> performance ---> select the call processor --->

Select the type of gateway.

Then graph what you need like ""ACTIVE CALLS "

2) If you can only use IOS commands then

"show voice call status | i active" will show active calls.

3) Or you can use SNMP for it :- cvCallActiveDS0s  is the OID.

Regards

Ronak patel

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.

View solution in original post

Ronak that for the information so far the RTMT is working, I will use step 3 if I need more information.

Thanks again,

Randy Haddon

Content for Community-Ad

Spotlight Awards 2021

This widget could not be displayed.